Chemical-Free

This antenna is free from high-concerned chemicals, making it a safe choice for your vehicle.

Universal Compatibility

This 7D Shark Fin Antenna is universally compatible with most car models, ensuring a perfect fit for your car,please check your antenna base size to comfirm it.

Dual Frequency Support

Designed to support both FM and AM frequencies, this antenna provides a wide range of radio reception options.

High-Quality Material

Manufactured by DA, known for its reliability, this antenna is made from high-quality materials, ensuring durability and longevity.

Safety Certified

With its CE external testing certification, you can trust that this antenna meets the highest safety standards.

7D Universal Auto Shark Fin Antenna Car Radio Antenna Aerial Receiver for Many Car Models 

Features and specifications:

Shark fin antenna made from ABS plastic. Features a double adhesive for a strong hold.

Note:
The shark bottom hole measures 9.8cm/3.86inch x 5.2cm/2.05inch. Please make sure your antenna base is smaller than that to ensure fit. Otherwise,it can not install.
The Bottom is flat.
 

Shark size and bottom hole size:

Shark fin:
Length 15.3cm(6.02inch),
Width: 6.84cm(2.69inch),
Height: 6.4cm(2.52inch)

Bottom hole:
Length: 9.8cm(3.86inch),
Width: 5.2cm(2.05inch)

Packing list:
Shark fin body 1 piece.
Copper Screw M5x10 1 piece.
Copper Nut M5 1 piece.
Double adhesive 1 piece.

Car show:

Shark colors show:

Chrome

Carbon Black

Black

Pearl Black

Matte Black

White

Pearl White

Silver

Gray

Dark Gray

Dark Red

Dark Blue

Easy to install

①Remove the original antenna,clean the area around the antenna base.

② Heating double adhesive,stick the double adhesive onto the bottom of the shark fin.

③ Tighten screw and nut on the original antenna base.

④ Carefully align the shark fin and press down for 2 minutes to assure adhesion.

Frequently Asked Questions

Question 1:Is the shark same color with original car color?
Answer 1:Shark fin color very close the original color,however, the car due to long-term exposure to outdoor, erosion by rain and snow,the color has changed, so impossible exactly the same as color,please understand.

Question 2:The shark installed on the roof have a little gap, is appropriate?
Answer 2:The shark bottom is flat,without curved,most of the hatchback models and SUV models no have gap,few sedan models roof is curved,there may be have a little gap,it does not affect the use.You can use adhesive in to the gap.

Question 3:How about the radio signal effect after installation?
Answer 3:This antenna using purification copper fittings,through our tested,the signal close to the original car antenna.

Question 4:What should be note when installing?
Answer 4:Clean around antenna base,be sure not have water and dust,first connect the cable and base,test the radio,if it is ok,than installing,heating double adhesive with hair dryer before you install,it will become soft,viscosity will increase,only have one chance to paste,so be sure to alignment the position pressing 3 minutes after pasted,keep dry in 2 days.